Flame Detector with Line of Sight model NFDL-2545

CategoryNFDL

This model is a Line of sight flame detector that is installed directly on the furnace. The light of flame by the optical lens is focused on the sensor. The sensor converts the light into electrical signals. The flame signal is analyzed by the central processor and monitored in the output.

Overview

1x NO contact, 24 VDC, 0.5 A	System status relay contact	250– 450 nm	Spectral sensitivity
0/4 … 20 mA, max. load 750 ohm	Flame intensity analogue output	24 VDC ±20%	Operating voltage
RS485, Modbus RTU	Interface protocol	5 W	Power consumption
IP66	Protection class	-40°C to +85°C	Ambient temperature
6°	Optical viewing angle	Safety Self-monitoring and fail-safe	Safety
∅120 mm, length 258 mm	Dimensions	1, 2, 3, 5 s	Safety time (FFRT)
approx. 2.5 kg	Weight	1x NO contact, 24 VDC, 0.5 A	Flame relay contact

Key Features

For ambient temperatures from -40°c up to +85°c;
Two parallel channels to increase the safety of the device;
Flame flicker frequency measurement;
Usable for all burners with different fuels.

Applications

Power stations;
Petrochemical industry;
Steel industry;
Cement factory;
Refineries;
Steam generators;
Waste incinerators;
Heating systems.

User Software Specifications

Application software Specifications and capabilities

Connection to 64 flame detectors, with only two strands of wires, by using RS485 connector and Modbus RTU protocol;
Display of switches regulation status of intensity and frequency thresholds, and the signal gain coefficient;
Display of wave shape, light intensity, and frequency of measured fluctuations from the stored flame light for required analyses;
The possibility of storing and implementing information in Excel format;
Installation capability on Windows operation system.